Honda WMP20XE1T Owner's Manual page 6

APPROVED LIQUIDS
The following is a list of chemicals that the multi-purpose pump is
capable of pumping. The operator must verify that the liquid that is to
be pumped is on these lists. After each use, drain the pump chamber
into a suitable container and flush with fresh water.
Do not use for pumping liquids for human consumption.
Do not use for pumping flammable liquids.
 WARNING
Chemicals can cause burns or serious injury.
Wear protective clothing and eye protection when handling
chemicals.
Follow the chemical manufacturer's handling procedures.
NOTICE
Pumping liquids that are not listed may cause damage to the pump.
Agricultural Chemicals
Aatrex Eradicane
Amiben Extrazine
Ammonium Larsban
Thiosulfate
Banvel Lasso
Basagran URAN Solutions
Bicep Modown
Bladex N-Serve 24
Dual Phosphoric Acid
Solutions
Industrial Chemicals
Acetic Acid, 20% Lactic Acid
Aluminum Sulfate Lead Acetate
Ammonium Nitrate Magnesium Chloride Sodium Carbonate,
Ammonium Sulfate Magnesium Nitrate
Barium Sulfate Magnesium Sulfate
Borax (Sodium Maleic Acid
Borate)
* Calcium Chloride Nickel Chloride
Citric Acid Nickel Sulfate
Copper Sulfate Oleic Acid
Detergents Phosphoric Acid,
(General) 0-80%
Ethylene Glycol Potassium
Carbonate
Fatty Acids Potassium Chloride
Ferric Nitrate Potassium Nitrate
Ferric Sulfate Potassium Sulfate
Ferrous Sulfate Soaps (neutral)
Formaldehyde, 40% Sodium Acetate
Glycerine (Glycerol) Sodium Bicarbonate
* Temperature does not exceed 26°C.
The temperature operating range of the pump is between
-7 ~ 54°C.
6
PUMP PERFORMANCE
The maximum pump discharge capacity is determined when pumping
clear water at 0 meters total head and at sea level. As the total head
[1] (discharge head [2] + suction head [3]) increases, pump discharge
capacity decreases (see figure). If the pump is used at higher
elevations, pump discharge capacity may also decrease. Other
factors affecting pump discharge capacity are:
• The type of chemical being pumped.
• The length and type of the suction and discharge hose used.
Poly-N
Ranger
Round-up
Sutan
Treflan
Vernam
Oil Alert® System
Sodium Bisulfate
The Oil Alert system is designed to prevent engine damage caused by
an insufficient amount of oil in the crankcase. Before the oil level in
Sodium Bisulfite
the crankcase can fall below a safe limit, the Oil Alert system will
automatically shut down the engine (the ignition switch will remain in
10%
the ON position).
Sodium Chlorate
If the engine stops and will not restart, check the oil level (page 9)
Sodium Chloride
before troubleshooting in other areas.
Sodium Nitrate
Sodium Silicate
Sodium Sulfate
Stearic Acid
Sulfuric Acid, 0-29%
Tartaric Acid
Vinegar
Water (Clear)
Water (Salt)
Zinc Sulfate
ENGLISH
[2]
[3]
Pump Performance (maximum with clear water)
Total head [1]
Suction head [3]
Discharge capacity
Self-priming time
Pressure
[1]
31 m
9.5 m
850 /min
47 sec at 5 m
300 kPa