Viessmann Vitodens 222-F Installation And Service Instructions For Contractors page 33

Commissioning the system with the commissioning...
Menu point
"Energy cockpit"
"Flue system"
(not Vitodens 3xx)
Calling up the commissioning assistant at a later
point
If you need to continue commissioning later, the com-
missioning assistant can be reactivated at any time.
Tap the following buttons:
1. "Menu"
Extended commissioning assistant
Settings and explanations
"ON"
■
The Energy cockpit with various scanning options is displayed.
"OFF"
■
The Energy cockpit is not displayed.
"Single connection"
■
Only one boiler is connected to the flue system.
"Multiple connections"
■
Several boilers are connected to the flue system.
Commissioning, inspection, maintenance
2. "Service"
3. Enter "viservice" password.
4. "Commissioning"
1. Call up the commissioning assistant with "Yes".
A safety instruction is shown on the display.
Note
The extended commissioning assistant can be
skipped with "No".
2. After successfully reviewing the safety instruction,
tap "Yes" to confirm. This starts detection of the
connected sensors and the system components
connected via KM-BUS.
This process may take some time.
3. After detecting the devices, tap "Next".
A list of detected system components (device list)
appears on the display.
4. Compare the device list with the system compo-
nents actually connected.
If any components were not detected, these can be
added later via the relevant parameters.
(cont.)
33