Table of Contents
Advertisement
Check the 3M
SpotOn
Temperature Monitoring System website to ensure you have the most recent version of this document.
TM
TM
14
Ready
The ready screen displays the serial number of the
SpotOn sensor and indicates the SpotOn sensor
cable and sensor are properly attached to the SpotOn
control unit. The SpotOn sensor is now ready to be
attached to the patient.
Equilibration
A flashing yellow temperature display indicates the
sensor has been connected to the patient and to the
control unit and is in the process of equilibration.
The graph below the temperature output indicates
the progress of equilibration. This process will take
approximately three minutes.
If you see a temperature in the upper left hand corner
of the screen, that is the last recorded temperature that
has been captured by the sensor on the patient's head.
The sensor captures and records a temperature every
five minutes.
After the equilibration is complete, the patient's body
temperature is displayed on the SpotOn control unit
in bold white numbers and can be automatically
transmitted to the patient monitor via the monitor
cable.
Running
The running screen displays the deep tissue
temperature of the patient in white. The trend graph
at the bottom of the screen displays the last two hours
of the patient's temperature in five minute increments.
The bars on the graph will begin filling from the right
with the 36°C always visible. The blue bars indicate
that the temperature dropped below 36°C (white
indicates the temperature is above 36°C).
Control unit error
The SpotOn control unit error screen displays when
there is a system error. Discontinue use of unit.
Contact a biomedical technician.
Sensor error
The sensor error screen displays when there is a
temperature sensor or cable error. See "Section 4:
Troubleshooting" on page 15 for details.
English 202052A
www.spotontemperature.com reorder #202052A
Display Panel
SN - 000000000
3 6 9
C
36 0
3 9
3 7
3 5
E-xx
E-xx
C
Advertisement
Table of Contents
