Ebyte E180-Z5812SP User Manual page 13

Chengdu Ebyte Electronic Technology Co., Ltd.
Network
status
Target Read/Write
network
address
Local MAC
address
Target Read/Write
MAC
address
Device type Read/Write
Channel Read/Write
Transmissio Read/Write
n mode
Output Read/Write
mode
TX power Read/Write
Remote Read/Write
configuratio
n ID
Local Read/Write
network
group
number
Target Read/Write
network
group
number
Wake up Read/Write
period
(sleep time)
Parent node Read/Write
lost
reconnectio
Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co.,Ltd.
12
Read 0、2、3
0x0000～0xFFFF
Read 64 bit MAC
64 bit MAC
E、S
CH11～26
0、1、2、3、4、
5
0、1、2、3、4、
5
-37dbm～7dbm
2 bytes
1～254
1～254
0～2010 / second
1～254 / minute
It indicates the network status of the device, including
no network, successfully joined the network, with
network but no parent node.
The communication target address (short address) can
be switched at any time through configuration
command.
The MAC address assigned by the network, can not be
changed by the user (changed when re-accessing the
network)
In fixed-point mode, long address is used
Non sleeping terminal and sleeping terminal
Physical channel of ZigBee communication
Broadcast mode, multicast mode, short address unicast
mode, long address unicast mode, protocol unicast mode
and protocol multicast mode. For details, please check
the corresponding mode introduction
Transparent communication, data+short address,
data+long address, data+RSSI, data+short
address+RSSI, data+long address+RSSI
In the case of high requirements for low power
consumption and no requirements for distance, the
transmission power can be reduced to save the average
power consumption
It is used to judge whether the data received by the
wireless is a remote configuration command. The user
can change the remote configuration ID according to the
need, and the default is A8 8A
It is used to configure the group number of the device in
the network
It is used to configure the group number of the
corresponding target during multicast
It is used to configure the wake-up cycle of the terminal
sleeping device. The larger the wake-up cycle, the lower
the overall power consumption, but the greater the delay
of receiving data
When the parent node is lost (the coordinator is powered
off), the terminal device reconnects to the previous
network at regular intervals
E180-Z5812SP User Manual