Ack Description; Uart_Baud_Reset Description; Wireless Remote Configuration Function; Function Parameter Description - Ebyte E180-Z5812SP User Manual

Chengdu Ebyte Electronic Technology Co., Ltd.

6.1.4 ACK description

ACK pin is used to indicate the status of the data transmission. The pin is low level before the transmission is started,
and high level after the transmission is successful. The user can judge whether the data is delivered successfully by the
pin status. This pin function can not be used to indicate the broadcast messages transmitted by coordinator. (Only for non
sleeping terminals).

6.1.5 UART_BAUD_RESET description

ART_BAUD_RESE pin is used to reset the baud rate of the device. The default value is high level. In any mode, if
U
the pin is pulled down for more than 1000ms, the module's serial port parameters will return to the default 115200 and
8N1.

6.2 Wireless remote configuration function

The module supports remote configuration function, which is identified by two byte wireless configuration ID
(default is A8 8A). The user can modify the remote configuration ID. When the module receives the first two bytes of the
wireless air data as the wireless configuration ID, the module judges that the data packet is the remote configuration
command and executes the corresponding operation of the command. The data packet will not be output through the
serial port. When configuring the sleep terminal remotely, it is necessary to wake it up first..

6.3 Function parameter description

The module provides a wealth of configurable parameters, which can be flexibly used according to the actual
application requirements to build different forms of network.
Parameter
PANID Read/Write
Local
network
address
Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co.,Ltd.
11
Pin
LINK
WAKE
AUX
ACK
UART_BAUD_RESET
Attribute Range
0x0000～0xFFFF
Read 0x0000～0xFFFF
Pin No
PC1
PD3
PB5
PB1
PA1
Description
PANID is the network identifier of ZigBee network,
which is used to determine the identity of its own
network. The PANID of all devices in the same network
must be the same. When the terminal or router is
configured as 0xFFFF, it can join any existing network
with the same channel.
It is used to distinguish each node in the network. The
local network address of each device in the same
network must be unique. When the device does not join
the network, the network address of the device is
0xFFFF. After joining, the short address of the device is
assigned by the coordinator. The local network address
of coordinator is fixed as: 0x0000.
E180-Z5812SP User Manual