Starting Engine - Volvo ECR50D Operator's Manual

Operating instructions
74

Starting engine

ON
OFF
The battery disconnect switch is located
in the front of the machine.
4
A
B
Control lockout lever (4)
1
0
2
P
STOP
3
V1087043
Ignition switch
P: Radio and cab interior light
0: Engine off
1: Running position / Ignition
2: Preheating
3: Start the engine
V1085793
Control lamp for preheating
Starting engine
Starting engine
1 Turn on the electric supply with the battery
disconnect switch.
V1090371
2 Shift control lockout lever (4) to position (A). You
are now able to start the engine and the
operating levers for working and travel
hydraulics are locked (no movement possible).
3 Insert the ignition key into the ignition switch and
turn it to running position / ignition (1). All control
and function lamps (except preheating lamp)
light up for a period of approx. 3 seconds, see
28 .
page
4 Enter the anti-theft code (optional equipment)
with the buttons on the keypad. The machine will
take on the settings which where adjusted with
V1138066
this code.
5 Turn the key to preheating position (2).
6 Preheat depending on engine temperature. The
preheating control light goes out after
preheating. However, if the ignition key remains
in preheating position (2), the preheating
function remains active, even though the control
lamp is off.
7 Once the preheating control lamp has gone out
turn the ignition key to start position (3) and start
the engine. As soon as the engine starts, release
the ignition key. Do not continue to start for
longer than 25 seconds without interruption.
8 If the engine does not start, turn the ignition key
back to engine off position (0) and repeat the
starting procedure.
9 Let the engine warm up during at least one
minute before operating the machine.