injen technology SP1870 Manual

Part number SP1870
2006-12 Mitsubishi Eclipse
2.4L 4 cyl.
Manual only
1- MR Tech intake system
1- 3" Injen filter
1- 2 7/8" straight hose
1- 3" straight hose
2- Power-Bands(.048)(.362)
2- Power-Bands(.040)(.312)
1- m6 Vibra-mount
1- m6 flange nut
1- Fender washer
1- M4x10 allen bolt
1- 4 page Instruction
Note: The C.A.R.B Exempt sticker must
be attached under the hood in a
manner such that it is easily viewed by
an emissions inspector
Note: Injen strongly recommends that this system be installed by a professional mechanic.
Figure 1
Cyborg Intake System
"The World's First Tuned air Intake System!"
Factory safe air/fuel ratio's for Optimum performance
Injens tuning process covered by three U.S. Patents
Congratulations! You have just purchased the best engineered,
dyno-proven cold air intake system available.
Please check the contents of this box immediately.
Report any defective or missing parts to the Authorized Injen
Technology dealer you purchased this product from.
Before installing any parts of this system, please read the instructions
thoroughly. If you have any questions regarding installation please
contact the dealer you purchased this product from.
(#1014)
Installation DOES require some mechanical skills. A qualified
(#3050)
mechanic is always recommended.
(#3044)
*Do not attempt to install the intake system while the engine is hot.
(#4004)
The installation may require removal of radiator fluid line that may be
(#4003)
hot.
(#6020)
Injen Technology offers a limited lifetime warranty to the original
(#6002)
purchaser against defects in materials and workmanship. Warranty
(#6010)
claims must be handled through the dealer from which the item was
(#6047)
purchased.
Injen Technology 244 Pioneer Place Pomona, CA 91768 USA
Please check the contents of this box immediately.
Note: This intake system was Dyno-tested with an Injen filter and
Injen parts. The use of any other filter or part will void the
warranty and CARB exemption number.
Parts and accessories are available on line at "Injenonline.com"
Warning: Manufactures attempting to duplicate Injen's
patented process will now face legal action.
1- Calibration Method for Air Intake Tracts for Internal Combustion Engines.
2- Calibration Device for Air Intake Tracts for Internal Combustion Engines.
3- Calibration Method and Device for Air Intake Tracts having Air Fusion Inserts

Tools required:

1- 10mm socket
1- 8mm socket
1- Phillips head screwdriver
1- Flat head screwdriver
1- 8mm nut driver
1- ratchet
1-2.5mm allen wrench
MR Technology Step down process:
Covered under Patent# 7,359,795
Published and patent pending
Published and patent pending
Optional:
Hydroshield
Application
number X-1033