Recording A Phrase - Casio CT-X9000IN User Manual

Phrase Playback Setup Items
Setup Item
(Display)
Looped playback Specifies whether or not to
(Loop) perform loop playback.
Off: Plays the phrase all the
way through and then stops.
On: Loops the phrase.
Key shift Changes the playback pitch
(KeyShift) in semitone units. A lower
setting value lowers the
playback pitch, while a
higher setting value raises
the pitch.
Timing Sync Specifies whether playback
(TimingSy) timing and speed when a
phrase pad is pressed
should be synced with a
previously playing Auto
Accompaniment, phrase, or
song recorded with the MIDI
recorder.
Off: No syncing.
Beat: Forces correction of
deviation in beat units.
Measure: Forces correction
of deviation in measure
units.
Chord Sync Enabling this function
(ChordSyn) automatically adjusts the
pitch of the phrase in
accordance with the chords
of an Auto Accompaniment
that is playing.
Important!
Note that Chord Sync can be
applied to a phrase recorded
in C Major only. Play and
record the phrase in C Major
and assign it to the
applicable pad. Next, turn on
Chord Sync for the pad.
Break Point This setting is applied while
(Break Pt) Chord Sync is turned on. It
specifies a note key, from C
to B, as the point at which
the phrase notes drop one
octave.
Description Settings
On, Off
–24 to 24
Off, Beat,
Measure
On, Off
C to B

Recording a Phrase

A phrase is created by recording notes played manually on
the keyboard. Up to 16 measures can be specified for the
length of the phrase to be recorded, and up to approximately
1,000 notes can be recorded. As with playback, recording
also loops back to the first measure when the end of the
number of measures specified for the phrase is reached. You
can add notes while listening to playback of previously
recorded content.
• The [RECORD] indicator will start to flash during recording
when the number of remaining note count is 100 or lower.
When there are no more remaining notes, recording stops
automatically and the [RECORD] indicator disappears.
To record a phrase
1.
Select the tone you want to use for phrase
recording.
• See "Selecting a Tone" (page EN-18).
• You cannot use layer or split when recording a phrase.
2.
Press bk FUNCTION.
3.
Use the [1] (V) and [3] (W) bm number keys
to display "Phr Pad", and then press [6]
(ENTER).
This displays "Phr Set".
4.
Use the bn [–] and [+], or the bl dial to select
the phrase set number you want to use for
phrase recording.
5.
Press 8 RECORD/STOP.
This enters record standby and causes the [RECORD]
indicator to flash. Also, the [P1] indicator will be flashing.
Flashing
• The indicators ([P2] through [P4]) of the phrase pads
that have phrases recorded will appear on the display.
• The [P1] indicator flashes even if there is already a
phrase recorded to the P1 phrase pad. You can
determine whether or not there is a phrase recorded to
the P1 phrase pad by pressing any cq PHRASE PAD
button other than [P1] in step 6. If the [P1] indicator is
displayed, it means there is a phrase recorded. If the
indicator is not displayed, it means nothing is recorded
to the P1 phrase pad.
• If you want to change mixer settings, perform the
procedure under "To configure mixer settings" (page
EN-62). To configure mixer settings of the phrase to be
recorded, configure the mixer settings of the
corresponding part (Part 6 through Part 9) of the
KEYBOARD part group. For example, when recording
to Phrase Pad 1, configure the mixer settings of Part 6
(Phrase Pad 1) of the KEYBOARD part group.
Using Phrase Pads
Flashing
EN-55