Battery Installation - Nissei DS-1011 Instruction Manual

BATTERY INSTALLATION

Fig.2
1. Open the battery compartment cover (fi g.2).
2. Install four "AA" type batteries into the compartment.
Make sure that the polarities correspond to the (+) and (–)
marks inside the battery compartment (fi g.3).
Batteries can be easily installed or removed as their (-) ends
are pushed against the spring.
You may use nickel hydride rechargeable batteries. These
batteries can not be charged with this product. Use the
designated battery charger.
3. Close the battery compartment cover.
Do not force the battery cover into position.
Operation With AC Adaptor
AC Adapter socket is located at the side of the device.
Connect the AC Adapter jack to the device fi rstly and after
supply AC Adapter plug into the power outlet, press «START /
STOP». To switch off the device after fi nishing the measurement
press «START / STOP», unplug the AC Adapter from the power
outlet and disconnect AC Adapter from the device.
ADJUST DATE AND TIME AND ACTIVATE THE CLOCK
Date and time can be set after installing the batteries.
Set the time guarantees the preservation of the measurement results with the correct date and time.
There is a possibility of measurement of pressure and pulse rate without setting date and time.
Fig.3
56
Battery symbol will fl ash when
battery power is low.
Measurement can not be made while the
symbol is displayed. Replace the batteries.
All four batteries need to be replaced with
new ones; do not mix new and old batteries
or diff erent batteries.
The symbol might appear only during
measurement although you can review
readings in memory. This is because more
battery power is required for conducting a
measurement, e.g. infl ating the cuff , than
displaying the readings in memory. Please
have the batteries replaced. The enclosed
batteries are for monitoring, and their life may
be shorter than that of commercial batteries.
The used electrical and electronic
products are not household waste.
Follow your national/local recycling
rules to dispose of them properly.
WARNING!
If you will switch off AC Adapter
without batteries in the device all
information stored in memory (results of
measurements, date and time) will erased.
If you want to save this information, do
not remove batteries from the device
when using the AC Adapter.