Correct Measuring Posture - Nissei ds-1902 Instructions Manual

4.
Year flashes on the display.
Clock can be set only after the batteries are reinstalled.
Adjust the clock so that measurement results are stored
with correct date and time.
Use MEMORY BUTTON to increase the flashing
year and MEMORY SELECTOR to decrease the
year.
Press START/STOP BUTTON to confirm and move
to next step.
5.
Month flashes.
Adjust the month with MEMORY BUTTON and/or
MEMORY SELECTOR, press START/STOP BUTTON
to confirm.
6.
Day flashes.
Adjust the day with MEMORY BUTTON and/or
MEMORY SELECTOR, press START/STOP BUTTON
to confirm.
7.
Hour flashes.
The clock is in 24 hour mode.
Adjust the hour with MEMORY BUTTON and/or
MEMORY SELECTOR, press START/STOP BUTTON
to confirm.
8.
Minute flashes.
Adjust the minute with MEMORY BUTTON and/or
MEMORY SELECTOR, press START/STOP BUTTON
to confirm.
Clock is set and the unit is turned off.
The clock is displayed while the unit is turned off.

CORRECT MEASURING POSTURE

Sit at the table and let the table support your arm as you take the blood pressure
measurement.
Make sure that the measurement location on the upper arm is at approximately the
same height as the heart, and that the forearm is extended naturally on the table and
does not move.
INSTALLING BATTERIES AND SETTING THE CLOCK
electronic
household waste. Follow your
national/local recycling rules to
dispose of them properly. In the EU
countries, please refer to waste
management symbol(s) marked on
the package or the instrument.
Operation with an AC adapter
AC
JACK is located
on the right side
of the unit.
Do not use any adapters other
than the one specified below.
Model
Output voltage
Input voltage range
Maximum electric load : 600mA or higher
Output plug polarity
Remove the batteries when
operating the unit with
AC adapter for extended
period of time.
Clock is reset when AC
adapter is unplugged.
- 14 -
The used electrical
products
ADAPTER
: JPI2245
: 6 VDC ±5%
: Standard voltage ±15%
: Center Minus
and
are not
fig.2