Preparing For Operation - H&S BW1000 LINEWRAP BW1000 LINEWRAP Operator's Manual

Hide thumbs

Table Of Contents

Table of Contents

1. The LINEWRAP is shipped with a dry battery. Acid must be added and the battery brought to a full

charge.

2. Fill the gas tank with gas and check the engine oil level, fill to full level if needed.

3. Start the engine, let it idle for a short period of time to warm up.

4. Release the tail/ramp hydraulic locking valve while keeping the manual lock bar connected.

5. Activate the hydraulic control lever to pressurize the tail/ramp system.

6. Disconnect the tail/ramp lock bar and rotate it

forward to the storage position.

Note; Stand aside of the tail/ramp when disconnecting

the lockbar in case there is an air pocket in the system

that would allow the tail/ramp to fall back upon removal.

7. Activate the hydraulic control lever to lower the tail/ramp.

Cycle the ramp up and down a few times to remove

any air pockets. Turn the wheel brake valve to the upright

or off position, lower the ramp and the wheel brake will set.

8. Turn the wheel brake valve to the straight or on position,

this will release the wheel brake. Raise the tail/ramp,

replace lock bar and close the tail/ramp hydraulic locking valve.

9. Activate the Start/Reset switch on the control box by pushing up and releasing. This switch must

always be activated before any functions of the control box will operate.

10. Place the Mode switch in the manual position and operate the functions of the wrapper.

11. Place the Mode switch in the automatic position and push the bale trip bar down in the front of the

machine to check for proper operation. When the pusher contacts the first electronic switch, the

hoop should engage, upon contact with the second switch, the hoop should stop and the pusher

return to the home position.

Mode

Switch

Hydraulic

Control

Lever