Table of Contents
Advertisement
OPERATION
CONTROLS
There are four switches on the control panel. The mode
selection switch allows the operator to wrap bales
manually, automatically, or from the optional remote
control (Remote handset shown). The Linewrap will
not operate in the remote position, unless the remote
option is installed on the machine. The manual hoop
switch allows the operator to rotate the hoop while in
the manual mode. The manual pusher switch allows
the pusher to be moved forward or reverse while in
the manual mode. The start/reset switch is to be used
after starting the engine or after the emergency stop
has been activated.
IF THE EMERGENCY STOP IS TRIPPED DURING
WRAPPING CYCLE, THE UNIT MUST BE
SWITCHED TO MANUAL OPERATION ON THE
CONTROL PANEL. PRESS THE START/RESET
SWITCH, THEN PRESS AND HOLD THE MANUAL
PUSHER AND HOOP SWITCHES TO BEGIN
WRAPPING AGAIN, WHILE HOLDING SWITCHES,
SELECT THE DESIRED MODE, AUTOMATIC OR
REMOTE ON THE CONTROL BOX TO CONTINUE
NORMAL OPERATION.
BALE ADJUSTMENT SWITCHES
Adjust the hoop start switch to the number 1 as shown.
Adjust the hoop stop/pusher return switch the same
amount of footage as the length of the bale (Markings
are in 1' increments). Example; with a 4' bale the hoop
stop/pusher return switch should be set at the number
5. Be sure wires from switches are placed in the
storage channel below switches.
Always shut engine
off before making
adjustments.
-19-
Advertisement
Table of Contents
