Operation; I-Control" Operator Unit; Top Feed Slot Operator Unit - Intimus OmniShred 85 Operating Instructions Manual

GB
base cabinet (Fig. 4).
Fig. 4 Casing with oil container
3

Operation

3 .1 "i-control" operator unit

1
9
8
7
6
1
Function button
2
Forward button
3
"Motor overload" / "Motor failure" pilot lamp
4
"Catch basket full" pilot lamp
5
Reverse button
6
"Door open" / "Safety glass open" pilot lamp
7
"Lubricate cutting mechanism" pilot lamp
8
"Material jam" pilot lamp (Blockage of regulating shaft
or cutting mechanism)
9 "Cutting mechanism ready" / "Cutting mechanism not
ready" curved pilot lamps
Fig. 5 "i-control" operator unit
= Function button
1
Turns the machine on and off, and stops the shred-
ding process.
NOTE!
After 15 min without use the machine auto-
matically switches to standby mode.
96048 1 06/20
= Forward button
2
Starts the shredding process.
= "Motor overload" / "Motor failure" pilot lamp
3
Lights up in the event of a motor overload or fai-
lure.
= "Catch basket full" pilot lamp
4
Lights up if the catch basket is full and needs to be
emptied.
= Reverse button
5
If the motor is still starts backward operation, if the
motor is running stops the operation.
000424
= "Door open" / "Safety glass open" pilot lamp
6
Lights up if the floor unit's door or the safety glass
is open (Fig. 6/1).
= "Lubricate cutting mechanism" pilot lamp
7
Flashes if the oil container needs to be replaced or
in case of problems with the oiler system.
= "Material jam" pilot lamp
8
Lights up if the cutting mechanism or regulating
shaft is jammed.
= "Cutting mechanism ready" / "Cutting mecha-
9
nism not ready" curved pilot lamps
Lights up green if the cutting mechanism can be
fed. Lights up red if the cutting mechanism is busy
and cannot be fed.
2

3 .2 Top feed slot operator unit

3
NOTE!
Opening the safety glass always stops the cut-
4
ting mechanism.
5
1
000083
2
1
2
Fig. 6 Top feed slot
= Safety glass
1
The machine only runs if the safety glass is closed.
= Handle
2
Feed the material through the device's top feed
slot. Closing the safety glass starts the cutting me-
chanism.
Safety glass
Handle
85/115 OmniShred
13