Table of Contents
Advertisement
User Guide
EM-PMI375
Installation
42 |
©
Danfoss | November 2021
When installing the connection box lid, make sure there are no foreign particles between the
connection box lid and the insulation and that all connection box fasteners are in place.
Missing or loose screws can compromise the insulation.
Make sure the power cables exit straight from the terminals and do not rub against the sharp
cable through-holes or other sharp edges which could wear out the cable insulation over
time.
Do not place any excess weight on the connection box lid(s).
The high voltage cables of the electric machine are connected to the connection box(es) of the electric
machine. The Figure below shows the components of the high voltage connection box assembly.
1. Remove the cover of the terminal box.
2. Install the power cables.
3. Install the cover of the terminal box back.
High voltage connection assembly structure
Part Number
Qty
24
12
25
1
26
3
Description
Bolt, socket head
Plate, T=5
Nut
Type
M6 x 16, ISO 7380, A4-70
Gasket extruding
M8, DIN 934, Zinked
BC265856307805en-000202
Advertisement
Table of Contents
