Siemens SIMATIC ET 200SP Equipment Manual page 57

Diagnostic message
Parameter F_CRC_Length
does not match the
generated values
Version of F parameter set
incorrect
CRC1 fault
Device-specific diagnostics
information, see manual
Inconsistent iParameter
(iParCRC error)
F_Block_ID not supported
Transmission error:
Inconsistent data (CRC error)
Transmission error: Timeout
(watchdog time 1 or 2
expired)
Acknowledge required to
enable channel(s) - as
channel error(s) are
remedied.
Watchdog tripped
Invalid/inconsistent firmware
present
Digital input module F-DI 8x24VDC HF (6ES7136-6BA01-0CA0)
Equipment Manual, 10/2021, A5E50578307-AA
Fault Meaning
code
45 The PROFIsafe driver has detected a
H
discrepancy in the CRC length.
46 The PROFIsafe driver has detected an
H
incorrect version of the F-parameters or
an invalid F_Block_ID.
47 The PROFIsafe driver has detected
H
inconsistent F-parameters.
48 The PROFIsafe driver has received
H
inconsistent fail-safe parameters.
4B The PROFIsafe driver has detected
H
inconsistent iParameters.
4C The PROFIsafe driver has detected an
H
incorrect Block ID.
4D The PROFIsafe driver has detected a CRC
H
error.
Possible causes:
• The communication between F-CPU
and F-module is interrupted.
• Impermissibly high electromagnetic
interference is present.
• An error has occurred during the sign-
of-life monitoring.
4E The PROFIsafe driver has detected a
H
timeout.
Possible causes:
• The F-monitoring time is set
incorrectly.
• A bus fault is present.
4F A channel fault was detected. A
H
confirmation is required to enable the
channel.
103 Possible causes:
H
• An impermissibly high
electromagnetic interference is
present.
• The F-module has detected an internal
error and reacted to it in a safety-
oriented manner.
11B The firmware is incomplete and/or
H
firmware added to the F-module is
incompatible. This leads to errors or
functional limitations when operating the
F-module.
Interrupts/diagnostic messages
6.3 Diagnostic messages
Remedy
Check the parameter assignment of the
PROFIsafe driver.
Check the parameter assignment of the
PROFIsafe driver.
• Check the communication link
between the F-module and the F-
CPU.
• Eliminate the cause of the
electromagnetic interference.
• Check the parameter assignment.
• Make sure that your
communication is operating
correctly.
Confirm the channel fault.
• Correct the fault. The module must
then be pulled and plugged, or the
power switched OFF and ON.
• If the F-module cannot be put into
operation anymore, consider a
replacement.
• Perform a firmware update for all
parts of the F-module and note any
error messages.
• Use only firmware versions released
for this F-module.
59