Digitaliocontrol - Toshiba teli DDU Series Instruction Manual

DigitalIOControl

This section describes DigitalIOControl category for the DU series.
This camera provides GPIO output selected by the register setting. And the polarity of the signal is able to
switch by the register setting. The following chart shows the specifications of the selectable signals.
Line0, 3, 4
(GPIO_Input)
Line2
(GPIO_Input/Output)
Line1, 5, 6
(GPIO_Output)
Copyright © 2019 Toshiba Teli Corpotration, All rights reserved.
Trigger
Exposure
VD
Sensor Output
Image Streaming
on Interface Bus
Timer0Active
ExposureActive
FrameActive
FrameTransfer
FrameTrigger
Wait
*AcquisitionActive is active during AcquisitionStart state.
Selectable signals
LineModeAll[1]
GPIO internal circuit diagram
Delay Duration
* All signals in this figure are Active Low.
99 / 172
LineInverterAll
TriggerSource
Internal Trigger
LineSource
Timer0Active
TimerControl
UserOutput
ExposureActive
FrameTransfer
FrameActive
FrameTriggerWait
UserOutputValueAll[1]
UserOutputValueAll[2]
UserOutput
UserOutputValueAll[5]
UserOutputValueAll[6]
LineStatusAll[0]～[6]
LineModeAll
http://www.toshiba-teli.co.jp/en/
D4289451A