Table of Contents
Advertisement
DigitalIOControl
This section describes DigitalIOControl features.
This camera provides GPIO output selected by the register setting. And the polarity of the signal is able to
switch by the register setting. The following chart shows the specifications of the selectable signals.
Line0
(GPIO_Input)
Line1
(GPIO_Input/Output)
Line2
(GPIO_Output)
Copyright © 2019 - 2021 Toshiba Teli Corporation, All Rights Reserved.
Trigger
Exposure
VD
Sensor Output
Image Streaming
on Interface Bus
Delay Duration
Timer0Active
ExposureActive
FrameActive
FrameTransfer
FrameTrigger
Wait
*AcquisitionActive is active during AcquisitionStart state.
Selectable signals
LineModeAll[1]
GPIO internal circuit diagram
91 / 156
* All signals in this figure are Active Low.
Internal Trigger
Timer0Active
UserOutput
ExposureActive
FrameTransfer
FrameActive
FrameTriggerWait
UserOutput
LineInverterAll
TriggerSource
LineSource
TimerControl
UserOutputValueAll[1]
UserOutputValueAll[2]
LineStatusAll[2]
LineStatusAll[1]
LineStatusAll[0]
LineModeAll
D4288264E
https://www.toshiba-teli.co.jp/en/
Advertisement
Table of Contents
