Table of Contents
Advertisement
DigitalIOControl
This section describes DigitalIOControl category for the DU series.
This camera provides GPIO output selected by the register setting. And the polarity of the signal is able to
switch by the register setting. The following chart shows the specifications of the selectable signals.
Copyright © 2017 TOSHIBA TELI CORPORATION, All rights reserved.
Trigger
Exposure
VD
Sensor Output
Image Streaming
on Interface Bus
Delay Duration
Timer0Active
ExposureActive
FrameActive
FrameTransfer
FrameTrigger
Wait
*AcquisitionActive is active during AcquisitionStart state.
Selectable signals
GPIO internal circuit diagram
* All signals in this figure are Active Low.
98 / 179
D4267042B
http://www.toshiba-teli.co.jp/en/
Advertisement
Table of Contents
