Table of Contents
Advertisement
Connection
Camera
(Mirco B)
Camera
(e-CON)
mounting unit
CPTC6M
(Round connector)
Notes on Connection:
- Please confirm the power supply of the camera off when plugging in or pulling out the I/O Connector. It causes the
breakdown.
- If your camera is used in a system where its connectors are subjected to strong repetitive shocks, its connectors are
possible to break down. If you use your camera in such a situation, use an USB3.0 cable with a lock screw, and
secure the camera cable as close as possible to the camera body for avoid physical shock to the camera connector.
- In the case that electric-wire of cable is long or thin, input and output voltage may not satisfy specifications of the
camera or your system by voltage drop. Please confirm wires' specifications before use them.
- When connecting two USB 3.0 cables and using it in dual mode, please use the same item (manufacturer, model
name, cable length).
-
Lost packets may occur by an electrical characteristic of the transmission line of USB3.0. (USB3.0 Interface Card,
USB3.0 Cable, and USB3.0 HUB).
Copyright © 2019 Toshiba Teli Corpotration, All rights reserved.
USB3.0 Cable
Control Packet
Stream Packet
e-CON Cable
1. Line2
2. Line1
3. GND
4. Line0
Round connector Cable
1. Line4
2. Line3
3. Line5
4. Line6
5. I/O GND
6. NC
(Standard A)
Interface Card
16 / 172
Host(PC etc.)
D4289451A
http://www.toshiba-teli.co.jp/en/
Advertisement
Table of Contents
