Installing The Power-Button Board - Dell P116G Service Manual

Steps
1. Remove the two screws (M2.5x5) that secure the right display hinge to the palm-rest and keyboard assembly.
2. Lift the right display hinge.
3. Lift the latch and disconnect the power-button cable from the system board.
4. Peel the adhesive tape above the power-button board.
5. Remove the two screws (M2x2) and the two screws (M2x3) that secure the power-button board to the palm-rest and
keyboard assembly.
6. Lift the power-button board off the palm-rest and keyboard assembly.

Installing the power-button board

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of power button and provides a visual representation of the installation procedure.
46 Removing and installing components