Steps
1. Place and slide the media-card reader onto its slot on the system board.
2. Align the screw hole on the media-card reader bracket with the screw holes on the system board and the chassis.
3. Replace the two screws (M3x5) that secure the media-card reader bracket to the system board and the chassis.
Next steps
1. Install the
3.5-inch
drive.
2. Install the
HDD and ODD
3. Install the
front
cover.
4. Install the
left-side
cover.
5. Follow the procedure in
Power-supply unit
Removing the power supply
Prerequisites
1. Follow the procedure in
2. Remove the
left-side
3. Remove the
front
cover.
4. Remove the
3.5-inch hard
5. Remove the
HDD and ODD
About this task
The following image(s) indicate the location of the power supply and provides a visual representation of the removal procedure.
38
Removing and installing components
cage.
After working inside your
Before working inside your
cover.
drive.
cage.
computer.
computer.