Mast - Mackworth SA180E Service Manual

9.15 – Mast
Within this section it will explain the correct procedure on removing and reinstalling the Mast for
servicing procedures or replacement.
Removal
Step 1 – Remove the Battery from the Stand Aid. (See section 9.1)
Step 2 – Remove all Cables from the Control Box. (See section 9.2)
Step 3 – Remove the Control Box from the Mast. (See section 9.3)
Step 4 – Remove the Attachment Bracket from the Mast. (See section 9.4)
Step 5 - Remove the Lift Actuator from the Stand Aid. (See section 9.5)
Step 6 –Remove the Upper Assembly from the Mast. (See section 9.6)
Step 7 – Remove the Base from the Stand Aid. (See section 9.14) – To remove the Mast, only
steps 2 and 3 within this section are required.
Refitting / Replacement
Step 8 - Refitting is a reversal of the removal process.
995064 – Revision A Page 35 of 36