Attachment Bracket - Mackworth SA180E Service Manual

9.4 – Attachment Bracket
In this section it will explain the correct procedure on removing and reinstalling the
Attachment Bracket for servicing procedures or replacement.
Removal
Step 1 – Remove the Battery (refer to section 9.1)
Step 2 – Remove the Cables/Leads from the Control Box (refer to section 9.2)
Step 3 – Remove the Control Box (refer to section 9.3)
Step 4 – Using a 3mm Allen Key, remove the three circled screws to release the Attachment
Bracket.
Refitting / Replacement
Step 5 - Refitting is a reversal of the removal process.
995064 – Revision A Page 19 of 36