Cable - Charger - Mackworth SA180E Service Manual

Step 4 - Remove the cable from any clips that are routing it along the Mast.
Refitting / Replacement
Step 5 - Refitting is a reversal of the removal process noting the following points:
A) When fitting the Cable into the Actuator port, ensure the locator aligns with the
locator inside the actuator port.
9.2.3 – Cable – Charger
Removal
Step 1 – Where Applicable, turn the charger off at the wall plug and remove
Step 2 – Detach the Charger lead from the snap lead by pulling them apart as shown.
Step 3 – Detach the snap Lead from its latch circled in the image below and pull the lead
connecter from the Control Box as arrowed.
995064 – Revision A Page 17 of 36