Knee Pad - Mackworth SA180E Service Manual

9.13 – Knee Pad
Within this section it will explain the correct procedure on removing and reinstalling the
Knee Pad for servicing procedures or replacement.
Removal
Step 1 – Using two 17mm Spanners, remove a nut from either side of the Knee Pad
Attachment Bar. Ensure to grab the Nylon Washer circled.
Step 2 – Slide the Threaded Bar through the Inner Knee Pad Pivot Assembly to remove the
Knee Pad. Ensure to grab the Nylon Washer circled.
Step 3 – Using Circlip Pliers, remove the two Circlips on the underside of the Outer Knee Pad
Pivot Assembly to remove the two pins that secure the Inner Knee Pad Pivot Assembly.
995064 – Revision A Page 31 of 36