Mitsubishi Electric Melsensor CF37-SR Settings Manual page 67

Train Code, Optimize Brightness, and Train Match String
Refer to 'TRIG Button' in 'Section 8.5 Inputs/Outputs.'
Optimize Focus and Read Configuration Code
Refer to 'TRIG Button' in 'Section 8.5 Inputs/Outputs.'
Tune
Refer to 'TUNE Button' in 'Section 8.5 Inputs/Outputs.'
Allow Buffered No Read Images
This function can be used only when "Continuous" is selected for a trigger type.
When "Continuous" is set for a trigger type, even if a buffer setting is configured to save all images, the images which cannot
be read are not saved to a buffer. By using this function, only the images which cannot be read can be stored in the buffer.
Clear Outputs
This is a function to reset all the outputs immediately after the signal is input. An output delay setting is not reset.
Debounce Delay
Detection time required for the code reader to recognize a trigger signal being enabled is set.
Set a small value for fixing the line-noise of electrostatic discharge (ESD), and a large value for fixing the noise of
electromechanical relays. Adjustment of the setting may be required to select the best value that fits the manufacturing
environment.
8
8 Application Steps
65
8.5 Inputs/Outputs