Advertisement
5
ADJUSTMENT
(1) Operation Check
Check operation after installation is completed.
1.
Allow approx. 1 minute to warm up after power is
supplied.
2.
After 1 minute, operate a walk test in the protected
area to check if the alarm is activated.
(Operation LED (red) lights when an alarm is
initiated.)
(2) Sensitivity adjustment (sensitivity volume)
It is usually unnecessary to adjust sensitivity which has
been set at the factory. Adjust sensitivity to low if small
animals activate the sensor.
6
TROUBLESHOOTING
Analyze possible problems according to the following table.
If normal operation can not be restored by these procedures,
contact either the dealer from whom you bought the unit or
TAKEX.
Symptom
Passibe Cause
No power supply,
●
Completely
broken wire or
inactive
incorrect voltage.
(Operation
Window shielded by an
●
LED doesn't
opaque substance.
lights.)
Sensitivity adjustment
●
too low.
Incorrect power supply.
●
Something moving in
●
protected area or rapid
Frequent
temperature variations.
alarm
Large electrical noise
(Operation
●
source such as power
LED lights
machine nearby or
too often.)
wiring too close to that
of the PIR.
Control panel
Poor contact, broken
●
fails to work
wire or defective
although
insulation of signal line.
LED lights.
Damaged alarm contact.
●
7
SPECIFICATIONS
Passive infrared sensor
PA-15WE PA-30NE
Model
Passive infrared
Detection system
24 (12 pairs) 2 (1 pair)
Sensitive zone
Wide angle
Coverage
(Max. 50° (15m))
Dry contact relay 1C
Reset : approx. 2 sec.
Output signal
Contact capacity : 30V, 0.5A (resistant load)
Red LED (Lights when sensor detects)
Operation LED
10.5V DC to 30V DC (non polarity)
Supply voltage
25mA or less
Current consumption
-2° F to 122° F (-20° C to +50° C)
Ambient temperature range
Indoor / Outdoor (Rain-proof)
Mounting position
Connection
Lead wire
17.5oz (500g)
Weight
Sensor : resin (white)
Appearance
Mounting portion : resin (dark gray)
In Japan
Takenaka Engineering Co., Ltd.
83-1, Gojo-Dori, Sotokan Nishi-iru, Higashino,
Yamashina-ku, Kyoto 607-8156, Japan
Tel : 81-75-501-6651
Fax : 81-75-593-3816
https : // www. takex-eng. co. jp /
Remedy
Correct power supply or
●
replace the broken wire.
Remove the shielding
●
substance.
Turn sensitivity up and
●
re-check operation.
Correct power supply.
●
Remove the cause.
●
Turn the sensitivity
●
down.
Relocate the device.
●
Change the path of
●
wiring.
Check wiring with a
●
tester.
Check alarm contact
●
operation with a tester.
Long range
(Max. 100° (30m))
In the U.S.
In Australia
Takex America Inc.
Takex America Inc.
151, San Zeno WAY
4/15 Howleys Road, Notting Hill,
Sunnyvale, CA 94086, USA
VIC, 3168
Tel : 408-747-0100
Tel : +61 (03) 9544-2477
Fax : 408-734-1100
Fax : +61 (03) 9543-2342
https : // www. takex. com
https : // www. takex. com
8
EXTERNAL DIMENSIONS
2.83
(φ72)
Sensitivity Volume
Wire lead
4.41
9
(φ112)
COVERAGE
PA-15WE (Wide angle)
●
15m
10m
5m
PA-30NE (Long range)
●
0
5m
(VARIABLE RANGE)
0
5m
Note :
TAKEX, passive infrared sensor is designed to detect infrared energy
variation caused by the presence of a human body.
Therefore note that similar variation in conditions in the protected area, due
to other reasons, may cause the sensor to create an alarm as it is unable to
distinguish between the sources.
When the sensor is used outdoors, moving objects with heat source (wind,
fallen leaves, small animals) may cause the sensor to create an alarm.
AVOID USING THE SENSOR FOR FULL-SCALE SECURITY PURPOSE.
Limited Warranty :
TAKEX products are warranted to be free from defects in material and
workmanship for 12 months from original date of shipment. Our warranty does not
cover damage or failure caused by Acts of God (including inductive surge by
lightning), abuse, misuse, abnormal usage, faulty installation, improper
maintenance or any repairs other than those provided by TAKEX. All implied
warranties
with
respect
to
TAKEX,
merchantability and implied warranties for fitness, are limited in duration to 12
months from original date of shipment. During the Warranty Period, TAKEX will
repair or replace, at its sole option, free of charge, any defective parts returned
prepaid. Please provide the model number of the products, original date of shipment
and nature of difficulty being experienced. There will be charges rendered for
product repairs made after our Warranty period has expired.
In the U.K.
Takex Europe Ltd.
Aviary Court, Wade Road,
Basingstoke, Hampshire. RG24 8PE, U.K.
Tel : (+44) 01256-475555
Fax : (+44) 01256-466268
https : // www. takex. com
1.42
1.61
(36)
(41)
8.31
4.17
(211)
(106)
15.83 MAX
(402)
φ3.29
(φ83.5)
4-φ0.24
4-φ0.16
(φ4)
(φ6)
Mounting Box
Mouting Base
(VARIABLE RANGE)
5m
10m
10m
15m
20m
25m
30m
10m
15m
20m
25m
30m
including
implied
warranties
No.04-541 B9015
15m
for
Advertisement
