Safety Instructions; General Safety Instructions - LOGICDATA LogicSP-2-1 User Manual

User Manual
LogicSP-2-1 / LogicSP-2-2

1.9. Safety Instructions

This user manual contains safety instructions to point out possible dangers and therefore allow safe
operation of the LogicSP control box. Please adhere to these safety instructions minutely!
Within this chapter you will find general safety instructions, which do not refer to a particular
procedure. Safety instructions that refer to a particular operation step are found in the corresponding
chapter of this manual. In addition to this you find safety instructions on the device itself.
1.9.1.

General Safety Instructions

Note: Carefully read the user manual before you mount/operate the LogicSP control
box!
Caution: Do not open this unit! Risk of electric shock.
Caution: Do not exceed the duty cycle printed on the type label!
Caution: Do not operate the LogicSP control with a mains voltage other than 110V ±6%
/ 60Hz (US Version) or 230V ±6% / 50/60Hz (European Version)!
The mains voltage required by your LogicSP control box is printed on the type label.
Caution: Use only the power cord shipped with your LogicSP control box! Check the
power cord for damage before operating the unit. Never operate this unit with a
damaged power cord.
Caution: Unplug the power cord before you plug-in / unplug handsets!
Danger: To prevent fire or shock hazard, do not expose this device to rain or moisture!
Page 8 of 29