Image Posting - Bosch AUTODOME IP 4000i NDP‑4502‑Z12 User Manual

AUTODOME IP 4000i
Notice!
Duplication of data places a heavy demand on the unit and can lead to impairment of the
image quality under certain circumstances.
Port
Assign a different port to each data stream if there are simultaneous data streams at the same
multicast address.
Enter the port address of the required stream here.
Streaming
Click the checkbox to activate multicast streaming mode for the relevant stream. An enabled
stream is indicated by a check mark.
Multicast packet TTL
You can enter a value to specify how long the multicast data packets are active on the
network. This value must be greater than one if multicast is to be run via a router.
9.7

Image Posting

You can save individual JPEG images on an FTP server at specific intervals. You can then
retrieve these images at a later date to reconstruct alarm events if required. In order to
configure image posting, and to save and retrieve JPEG images, you must create an Account in
which to save and access them. If you have not configured an account, the following error
message appears at the top of this page: "No configured account. Configure accounts." Click
the link to access the Accounts page.
JPEG
Image size
Select the size of the JPEG images that are to be sent from the camera. JPEG resolution
corresponds to the highest setting from the two data streams.
File name
Select how file names are created for the individual images that are transmitted.
–
–
–
VCA overlays
To include VCA overlays in the email, select this check box.
Posting interval
Enter the interval in seconds at which the images are sent to an FTP server. Enter zero for no
images to be sent.
The following field may or may not appear, depending on your camera:
Target
Select the target account for JPEG posting.
Face detection
When face recognition is available, selected images of the face can be sent to a target
account.
Bosch Security Systems
Overwrite: The same file name is always used and any existing file will be overwritten by
the current file.
Increment: A number from 000 to 255 is added to the file name and automatically
incremented by 1. When it reaches 255, it starts again from 000.
Date/time suffix: The date and time are automatically added to the file name. When
setting this parameter, ensure that the date and time of the device are always set
correctly. For eample, the file snap011005_114530.jpg was stored on October 1, 2005 at
11.45 and 30 seconds.
User Manual
Network | en 67
2020-06 | 2.0 |