Advanced - Bosch AUTODOME IP 4000i NDP‑4502‑Z12 User Manual

64 en | Network
Status
The status of the DynDNS function is displayed here for information purposes. You cannot
change any of these settings.
9.4

Advanced

The settings on this page are used to implement advanced settings for the network.
Cloud-based services
Operation
The operation mode determines how the camera communicates with the Bosch Remote
Portal.
–
–
Cloud state
This field identifies any cloud-based services with which the camera communicates.
–
–
Stratocast
Enter the Stratocast Registration code to connect with the Genetec's Stratocast cloud.
Click Register to activate the account.
RTSP port
If necessary, select a different port for the exchange of the Real Time Streaming Protocol
(RTSP) data from the list. The standard RTSP port is 554. Select Off to deactivate the RTSP
function.
Authentication
If a RADIUS server is employed in the network for managing access rights, authentication must
be activated here to allow communication with the unit. The RADIUS server must also contain
the corresponding data.
To configure the unit, you must connect the camera directly to a computer using a network
cable. This is because communication via the network is not enabled until the Identity and
Password parameters have been set and successfully authenticated.
Identity
Enter the name that the RADIUS server is to use for identifying the camera.
Password
Enter the password that is stored in the RADIUS server.
TCP metadata input
TCP port
The device can receive data from an external TCP sender, for example an ATM or POS device,
and store it as metadata. Select the port for TCP communication. Select Off to deactivate the
TCP metadata function.
Sender IP address
Enter the IP address of the TCP metadata sender here.
2020-06 | 2.0 |
Select On to poll the server constantly.
Select Off to block polling.
If you have registered the device on a cloud-based service such as Bosch Remote Portal,
then this field identifies this fact ("Registered on Bosch Remote Portal").
Note: The button (Connect to Bosch Remote Portal) to connect to the device with that
service is active.
If you have not registered the device, then the message, "Not running. (Automatic IP
assignment not active)" appears.
Note: The button (Connect to Bosch Remote Portal) to connect to the device with that
service is not active.
User Manual
AUTODOME IP 4000i
Bosch Security Systems