Accounts; Ipv4 Filter; Encryption - Bosch AUTODOME IP 4000i NDP‑4502‑Z12 User Manual

68 en | Network
Enable
Select this check box to enable face detection.
File format
Select the file format in which to save images. Options are JPEG (default), YUV420, TIFF.
Target
Select the target account for JPEG posting.
Timeout [s]
Enter the number of seconds after which image posting will time out. The default is 0 (no
timeout).
Maximum image width [px]
Enter a number for the maximum width, in pixels, for the saved images. For automatic width
selection, use value "0."
9.8

Accounts

Four separate accounts can be defined for posting and recording export.
Type
Select either FTP or Dropbox for the account type.
Before using a Dropbox account ensure that the time settings of the device have been
correctly synchronized.
Account name
Enter an account name to be shown as the target name.
IP address
Enter the IP address of the server on which you wish to save the JPEG images.
Login
Enter the login ID for the server.
Password
Enter the password that gives you access to the server. To verify the password, click the
Check button to the right.
Path
Enter the exact path on which you wish to post the images on the server. To browse for the
correct path, click the Browse button to the right.
Maximum bit rate
Enter the maximum bit rate for the JPEG images (in kbps).

Encryption

Tick the box to use a secure FTP over TLS connection.
9.9

IPv4 Filter

Use this setting to configure a filter that allows or blocks network traffic that matches a
specified address or protocol.
IP Address 1 / 2
Enter the IPv4 address that you want to allow or block
Mask 1 / 2
Enter the subnet mask for the appropriate IPv4 address.
9.10 Encryption
If an encryption license is installed, this submenu gives access to the encryption parameters.
2020-06 | 2.0 | User Manual
AUTODOME IP 4000i
Bosch Security Systems