Display Stamping - Bosch AUTODOME IP 4000i NDP‑4502‑Z12 User Manual

AUTODOME IP 4000i
First, check the time zone setting. If it is not correct, select the appropriate time zone and
click Set.
1.
2.
3.
4.
5.
6.
7.
8.
Time server address
The camera can receive the time signal from time server using various time server protocols,
and then use it to set the internal clock. The unit polls the time signal automatically once every
minute.
Enter the IP address of a time server here.
You can choose to have the DHCP server give a time server date by selecting the Overwrite by
DHCP option.
Time server type
Select the protocol that is supported by the selected time server.
–
–
–
–
Click Set to apply the changes.
4.4

Display Stamping

Various overlays or "stamps" in the video image provide important supplementary information.
These overlays can be enabled individually and are arranged on the image in a clear manner.
Camera name stamping
This field sets the position of the camera name overlay. It can be displayed at the Top, at the
Bottom or at a position of your choice that you can then specify using the Custom option. Or
it can be set to Off for no overlay information.
1.
2.
3.
Optionally, tick the Underlay with full-width black bar box to place a black bar beneath the
time stamp.
Logo
To place a logo on the image, select and upload an uncompressed .bmp file with a maximum
size of 128x128 pixels and 256 colors to the camera. Its position on the image can then be
selected.
Bosch Security Systems
Click Details to edit the DST table.
Select the region or the city which is closest to the system's location from the list box
below the table.
Click Generate to fill the table with the preset values from the unit.
Click one of the entries in the table to make changes. The entry is highlighted.
Click Delete to remove the entry from the table.
Choose other values from the list boxes under the table, to change the selected entry.
Changes are immediate.
If there are empty lines at the bottom of the table, for example after deletions, add new
data by marking the row and selecting values from the list boxes.
When finished, click OK to save and activate the table.
Select Time protocol if the server uses the protocol RFC 868.
The SNTP protocol supports a high level of accuracy and is required for special
applications and subsequent function extensions.
Select TLS protocol if the server uses the RFC 5246 protocol.
Select Off to disable the time server.
Select the desired option from the list.
If you select the Custom option, additional fields are displayed where you can specify the
exact position (Position (XY)).
In the Position (XY) fields, enter the values for the desired position.
User Manual
General | en 17
2020-06 | 2.0 |