End Stop Closed: Set - AUMA SQEx 05.2 Operation Instructions Manual

Commissioning (basic settings)
Information
9.2.1.

End stop CLOSED: set

32
Exposed, rotating parts (discs/balls) at the valve!
Pinching and damage by valve or actuator.
End stops should be set by suitably qualified personnel only.
Never completely remove the setting screws [2] and [4] to avoid grease leakage.
Observe dimension T
The swing angle set in the factory is indicated on the name plate:
The setting sequence depends on the valve:
- Recommendation for butterfly valves: Set end stop CLOSED first.
- Recommendation for ball valves: Set end stop OPEN first.
Figure 25: End stop
[1] Screw plug for end stop OPEN
[2] Setting screw for end stop OPEN
[3] Screw plug for end stop CLOSED
[4] Setting screw for end stop CLOSED
Dimensions/sizes 05.2
T (for 90°) 17
T 11
min.
1. Remove screw plug [3].
2. Move valve to end position CLOSED with handwheel.
SQEx 05.2 SQEx 14.2 / SQREx 05.2
min.
07.2 10.2
17 20
11 12
SQREx 14.2
AMExC 01.1
12.2 14.2
23 23
13 12