Changing Parameter Settings - MAGUIRE WEIGH SCALE BLENDER Installation Operation & Maintenance

B L E N D E R 
W E I G H S C A L E

Changing Parameter Settings

To change a PARAMETER, the sequence of keystrokes is as follows:
Making Changes to Parameters - Keypad Sequence:
Switch the STOP END OF CYCLE switch DOWN:
Turn POWER ON. Wait 5 seconds, until display says WAITING
Press
Press
To alter a PARAMETER:
Press
Press
Press
Press
Additional information can be found in the KEYPAD section.
Display will say: ENTER PASSWORD
Display will say: PROGRAM
This is the PROGRAM MODE
Press repeatedly until the parameter you want is displayed.
If you accidentally pass it, use the * key to back up.
With the proper parameter displayed, enter the NEW number.
Enter 5 digits; use leading zeros if necessary.
For correct entries, follow specific directions given in the
PARAMETER section.
Display will say: PROGRAM
Display will say: SAVE USER SETTINGS
This saves the changes made
Display will say: PROGRAM when settings are complete.
M A G U I R E P R O D U C T S , I N C .
84