Changing Parameters - MAGUIRE Ultra-600 Installation Operation & Maintenance

ULTRA By Maguire - Ultra Low Energy Dryer

Changing Parameters

Changing parameters can have an impact on the Dryers performance. It is highly
recommended that a supervisor change the default Program Mode password to
protect the parameter values. Prior to making any parameter changes, make sure
you understand what you are doing.
Navigating and Making Changes to Parameters:
Press Display will prompt for a password. (default: 22222)
Press Dryer Configuration
Press Parameters
Press The category that would
contain the parameter you
want to adjust.
Press The parameter that you
want to adjust.
Press
Display will show the Dryer Configuration categories.
Display will show the categories of Parameters.
Parameters are divided into 6 categories. Blower, Heater,
System, Dispensing, Load-Cell, and Vacuum.
Categories will have several parameters indicated by a 3-letter
acronym on the left of the screen.
Some categories have multiple pages. Navigate pages using
the arrow buttons at the lower-left of the screen.
Display will show 5 digits.
Press the up or down arrows to adjust.
To save the parameter adjustment or
press the red X to cancel and exit.
Rev. June 11, 2020 – ULTRA-600 Touchscreen
Maguire Products, Inc.
Then press:
55