Getting Started - Read This Page - MAGUIRE WEIGH SCALE BLENDER Installation Operation & Maintenance

B L E N D E R 
W E I G H S C A L E
Getting Started – Important!
Blender Part Identification
Controller Parts Identification
Setup and Installation
Wiring Considerations
Check Out Procedure
Model Selection
Load Cell Calibration
Material Flow Rate
Calibration
Normal Operation &
Saving the Configuration
Lockout/Tagout, Cleaning,
Maintenance.
Page: 10 Identifying key parts of the blender and what they do.
Page: 10 Identifying the key parts of the blender controller.
Page: 16 Assembly, setup and installation instructions.
Page: 21 How to minimize electrical interference.
Page: 23 Step by step procedure to verify correct assembly.
Page: 22 How to verify and change your model selection. All new
blender controllers are pre-configured with the model
from factory. New, spare or swapped controllers may
require a model change.
Page: 26 Load Cells of new blenders are calibrated at the factory.
However shipping or rough handling can create load cell
problems. If weight readings are not correct, you MUST
recalibrate the load cells.
Page: 28 A flow rate calibration is not necessary because the
blender will learn the flow rate over time however if you
change equipment or material you may want to re-
calibrate the material flow rate.
Page: 30 How to start the blender and save / restore the
configuration.
Page: 109 How to Lockout/Tagout, Clean and Maintain your
blender.
M A G U I R E P R O D U C T S , I N C .
7