Table of Contents
Advertisement
INSTALLATION
Above: typical leg installation.
Leg Installation
There are four, 4" legs provided for 2, 3 and
4 foot griddles.
There are eight 4" legs provided for 5 and 6
foot griddles.
The legs are shipped in the grease drawers
of the griddle. Install them into the threaded
holes on the underside of the griddle body.
Leveling adjustment may be done by
screwing the bottom portion of the leg in and out.
:
THIS APPLIANCE MUST BE GROUNDED AT THE TERMINAL
PROVIDED. FAILURE TO GROUND THE APPLIANCE COULD RESULT IN
ELECTROCUTION AND DEATH.
WARNING
INSTALLATION OF THE UNIT MUST BE DONE BY PERSONNEL
QUALIFIED TO WORK WITH ELECTRICITY AND PLUMBING. IMPROPER
INSTALLATION CAN CAUSE INJURY TO PERSONNEL AND/OR DAMAGE
WARNING
TO EQUIPMENT. UNIT MUST BE INSTALLED IN ACCORDANCE WITH ALL
APPLICABLE CODES.
NOTICE:
The data plate is located on the right side of the griddle. The grill voltage,
wattage, serial number, wire size, and clearance specifications are on
the data plate. This information should be carefully read and understood
before proceeding with the installation.
NOTICE:
The installation of any components such as a vent hood, grease extractors,
fire extinguisher systems, must conform to their applicable National, State
and locally recognized installation standards.
ALWAYS KEEP THE AREA NEAR THE APPLIANCE FREE FROM
COMBUSTIBLE MATERIALS.
CAUTION
KEEP FLOOR IN FRONT OF EQUIPMENT CLEAN AND DRY. IF SPILLS
OCCUR, CLEAN IMMEDIATELY, TO AVOID THE DANGER OF SLIPS OR
FALLS.
WARNING
Marine Bolt Down Leg
For bolt down legs see above illustration for dimensions.
8
IL1554
Std Leg
2.5"
IL1550
Advertisement
Table of Contents
