Table of Contents
Advertisement
Installation -
Standard Installation
3
Mounting Template
1.
2
2.
3.
4
4.
5.
5
6.
5
6
7.
7
8
Using the mounting template sheet or the
camera itself, mark and drill the necessary
holes in the wall or ceiling.
Pass the wires through the mount bracket and
make all necessary connections. See page 10
for more information.
To use the camera's waterproof wiring:
a. Install the LAN cable into (a) .
b. (b) will be assembled to (a) with a 1/4 turn.
c. Thread (c) tightly to (b).
b
a
NOTE: to ensure a proper moisture seal,
make sure the o-ring is in place between (a)
and (b). In extreme environments, use an
outdoor-rated sealer.
NOTE: When using the waterproof cap,
crimp the RJ-45 connected after passing the
camera through the waterproof cap.
Mount the camera base to the mounting
surface using the included mounting screws.
Adjust the camera module's position by using
its 3-axis gimbal. The camera ca:
•
Rotate: 360°
•
Pan: 355°
•
Tilt: 60°
Assemble the cover over the camera body. Be
sure to assemble the cover and bottom case
to match the case outline.
When the installation is completed, remove
the protective film.
c
Advertisement
Table of Contents
