Table of Contents
Advertisement
Installation -
Disassemble the camera
Before installing your camera, you have to read the following cautions.
1. The mounting surface must withstand five times the camera weight.
2. Do not let the cables get caught in improper places or the electric line cover can be damaged. This may
cause a short or fire.
3. For the installation process, remove the dome cover from the camera module by loosening the two (2)
screws on the dome. Use the star wrench provided with the camera.
LED ON/OFF
Reset Button
When placing the cover back on the camera, also
make sure to align the cover and bottom case to
match the case outline.
Reset to the Factory Default
Press the reset button for 5 seconds to return the
setup to the factory default.
Warning:
If you press the 'Reset' button, you will lose all
setting data. If needed, please, make a note for
further installation.
The camera has a manual IR switch, located
under the camera's lens. You can use this switch
to manually turn the IR LED board on or off
according to the installation needs.
7
Advertisement
Table of Contents
