Functions - ADA INSTRUMENTS WHEEL 50 DIGITAL Operating Manual

Measuring wheel

Table of Contents

Available languages

WHEEL 50

DIGITAL

FUNCTIONS

1. ON/OF — Switch

2. М/ft – shift between metrical and imperial size. When one system is selected, the relevant sign is displayed

at the right side of the display. M means metric, ft means imperial.

3. SM – memory. Push this button to store measured data. It will show M1, 2, 3 .......respectively.

4. RM- recall data. When the data is stored you can read the memory from M1 to M5. E.g. if you store 5M in M1,

10M in M2, while the current measured data is 120.7M. When you press the RM button once, it will show the

data of M1 and also "R" sign at the right corner. A few seconds later the display will be back to show the current

measured data again. If you press the RM button twice, it shows the stored data of M2. "R" sign is at the right

corner. In several seconds the display will be back to show the current measured data again.

5. CLR –clear the current measured data. Press this button twice to clear the current measured data.

MEASUREMENT FOUNDATION

Table of Contents

Table of Contents

Do you have a question about the WHEEL 50 DIGITAL and is the answer not in the manual?