Connecting The Power Cord; Using Cable Ties (Standard Psu) - Fujitsu PRIMERGY TX1330 M4 Operating Manual

Starting up
5.5.3

Connecting the power cord

In its basic configuration the server has a permanently installed PSU or a hot-
plug PSU. Besides the hot-plug PSU, a second hot-plug PSU can be installed
optionally to serve as a redundant power supply. If one PSU fails, the second
PSU in the redundant configuration ensures operation can continue
uninterrupted.
V
CAUTION!
The server is automatically set to a mains voltage in the range 100 V -
240 V. You may only operate the server if its rated voltage range
corresponds to the local mains voltage.
Ê Connect the power cord to the PSU.
Ê Connect the mains plug to a grounded mains outlet in the in-house power
supply network.
I
It takes about 60 seconds until the server can be powered on.
5.5.3.1

Using cable ties (standard PSU)

You can secure the power cord using a cable tie to ensure that the insulated
connector cannot be disconnected from the server accidentally. The cable tie is
included in the accessories pack that is delivered together with the server.
70 Operating Manual
TX1330 M4