Yamaha AN1x Owner's Manual page 45

Ga te Tim e (1 ~ 2 0 0 %):
no te duratio n fo r the step.
Control Cha nge (0 ~ 1 2 7 ):
value o f the MIDI Co ntro l Chang e messag e to be
o utput by the step.
Control Change setting ( off, CC1 ~ 9 5 , After Touch) is determined by the Control
No ( Number) parameter in the SEQ EDIT/ SETUP menu. For more information, see
page 9 1 .
For more information about Event parameters, see page 8 9 .
Ste p Hold
The Step Ho ld functio n is used during step event
editing . W hen yo u press Step Ho ld [UP/ DO W N ] and
set it to " o n" , a sing le step will play repeatedly, based
o n the T empo and Pattern Base Unit setting s, in o rder
to fine-tune the events fo r the specific step. This lets yo u
adjust the vario us event setting s in co ntext with the
speed and reso lutio n o f the sequence.
Pattern
Knob
Event 1-8 / 9 -16 Step Hold Bank No Base Unit
Each time yo u press a different CO N TRO L kno b's push
switch while Step Ho ld is active, that step will be
played, and its info rmatio n will appear in the L CD.
T urning a CO N TRO L kno b will edit the current event
value o f the selected step.
L ets yo u determine the
L ets yo u set the
SEQ SEQ
Length LoopType Ctrl No Store EDIT / SETUP
45
W hile Step Ho ld is active, yo u can press Event
[UP/ DO W N ] to select the type o f event yo u want to
edit, then turn the CO N TRO L kno b acco rding ly.
T o turn the Step Ho ld functio n o ff, simply press Step
Ho ld [UP/ DO W N ] ag ain and switch it to " o ff" .
For more information, see page 8 9 .
1 - 8 / 9 - 1 6
Press 1 -8 / 9 -1 6 [UP/ DO W N ] to cho o se the step series
within which the step yo u want to edit is, then press a
CO N TRO L kno b's push-switch to select a specific step.
Current info rmatio n abo ut the step will display in the
L CD.
Knob Pattern
1-8 / 9 -16 Base Unit
Event Step Hold Bank No
SEQ
SEQ
Store EDIT / SETUP
Length LoopType Ctrl No