Mitsubishi MELSEC-A A2USHCPU-S1 User Manual page 181

11. TROUBLESHOOTING
Table 11.1 Error Code List for the AnUCPU, A2US(H)CPU, A2ASCPU and A2USH board (Continue)
Error
Error Massage Code
(D9008)
"CAN'T 13
EXECUTE (P)"
(Checked at
execution of
instruction.)
Detailed
Error CPU
Code States
(D9091)
131 STOP The same device number is used at two
or more steps for the pointers (P) and
interrupt pointers (I) used as labels to
be specified at the head of jump
destination.
132 Label of the pointer (P) specified in the
the
CJ
LEDA/B FCALL
instruction is not provided before the
END
133 (1) The
in the program and executed
though the
not given.
(2) The
instructions were included in the
program and executed though the
FOR
(3) Nesting level of the
and
deeper, and the 6th level was
executed.
(4) There is no
instruction at execution of the
or
134 The
the program and executed though no
sub program was provided.
135 (1)
LEDA IX
instructions are not paired.
(2) There are 33 or more sets of
LEDA IX
instructions.
Error and Cause
, , , ,
CALL
SCJ CALLP
JMP
or
LEDA/BBREAK
instruction.
instruction was included
RET
instruction was
CALL
NEXT LEDA/BBREAK
instruction was not given.
,
CALL CALLP
instructions is 6 levels or
FOR
or
RET NEXT
CALL
instruction.
FOR
instruction was included in
CHG
and
LEDAIXEND
and
LEDAIXEND
11 - 14
Corrective Action
Eliminate the same pointer numbers
provided at the head of jump destination.
Read the error step using a peripheral
, device, check contents and insert a jump
destination pointer (P).
(1) Read the error step using a
peripheral device, check contents
and correct program of the step.
(2) Reduce the number of nesting levels
of the ,
CALL CALLP
instructions to 5 or less.
Read the error step using a peripheral
device and delete the
CHG
circuit block.
(1) Read the error step using a
peripheral device, check contents
and correct program of the step.
(2) Reduce the number of sets of
and
LEDAIXEND
LEDA IX
instructions to 32 or less.
and
FOR
instruction