Ferrite Core - Mitsubishi MELSEC-A A2USHCPU-S1 User Manual

9. EMC AND LOW VOLTAGE DIRECTIVES
(b) When wiring with cable that exceeds 2m (6.56ft.), but is 10m (32.81ft.) or less
• Ground the shield section of the external wiring cable with the cable clamp.
(Ground the shield at the closest location to the A1SD75 external wiring
connector.)
• Install a ferrite core.
• Wire the external wiring cable to the drive unit and external device with the
minimum distance of cable.
(c) Ferrite core and cable clamp types and required quantities
• Cable clamp
Type : AD75CK (Manufactured by Mitsubishi Electric)

• Ferrite core

Type : ZCAT3035-1330 (TDK ferrite core)
Contact: TDK Corporation
• Required quantity
Cable length
Within 2m (6.56ft.)
2m (6.56ft.) to 10m (32.81ft.)
(d) Cable clamp mounting position
Inside control panel
A1SD75
AD75CK
Prepared part
AD75CK
AD75CK
ZCAT3035-1330
20 to 30cm
(7.87 to 11.81inch)
9 - 7
Required Qty
1 axis 2 axes
1 1
1 1
1 2
3 axes
1
1
3