Mitsubishi MELSEC-A A2USHCPU-S1 User Manual page 180

11. TROUBLESHOOTING
Table 11.1 Error Code List for the AnUCPU, A2US(H)CPU, A2ASCPU and A2USH board (Continue)
Error
Error Massage Code
(D9008)
"PARAMETER 11
ERROR"
(Checked at
power on and at
STOP/PAUSE
RUN.)
"MISSING END 12
INS"
(Checked at
STOP RUN.)
Detailed
Error CPU
Code States
(D9091)
111 STOP Capacity settings of the main and sub
programs, microcomputer program, file
register comments, status latch, sampl-
ing trace and extension file registers
are not within the usable range of the
CPU.
112 Total of the set capacity of the main and
sub programs, file register comments,
status latch, sampling trace and
extension file registers exceeds
capacity of the memory cassette.
113 Latch range set by parameters or
setting of M, L or S is incorrect.
114 Sum check error
115 Either of settings of the remote RUN/
PAUSE contact point by parameters,
operation mode at occurrence of error,
annunciator indication mode, or STOP
RUN indication mode is incorrect.
116 The MNET-MINI automatic refresh
setting by parameters is incorrect.
117 Timer setting by parameters is
incorrect.
118 Counter setting by parameters is
incorrect.
121 STOP The
not given in the main program.
122 The
given in the sub program if the sub
program is set by parameters.
123 (1) When subprogram 2 is set by a
parameter, there is no END (FEND)
instruction in subprogram 2.
(2) When subprogram 2 is set by a
parameter, subprogram 2 has not
been written from a peripheral
device.
124 (1) When subprogram 3 is set by a
parameter, there is no END (FEND)
instruction in subprogram 3.
(2) When subprogram 3 is set by a
parameter, subprogram 2 has not
been written from a peripheral
device.
Error and Cause
END ( ) instruction is
END FEND
( ) instruction is not
END FEND
11 - 13
Corrective Action
Read parameters in the CPU memory,
check the contents, make necessary
corrections and write them again to the
memory.
Read parameters in the CPU memory,
check the contents, make necessary
corrections and write them again to the
memory
Write the instruction at the end of
END
the main program.
Write the instruction at the end of
END
the sub program.