HUBER+SUHNER 716 Series Assembly Instruction

Assembly instruction Series 716
Connector type: (e.g.) 11_716-50-7-1, 21_716-50-7-1, 25_716-50-7-1
RG_213_U, RG_214_U
Suitable cables: (e.g.)
Parts list connector:
A
Assembly steps:
Picture
A
A
The cable assembly of R.F. connectors can only be done by well trained assembly staff and suitable assembly equipment.
Huber+Suhner's skilled staff and specialised equipment are available to carry out complete R.F. lead-assembly on your behalf.
We mount your connectors on cables at economic prices! Please contact our representative for further details of this service.
B
Process
29
20
Slide ferrule A onto
cable. Prepare cable
7
according to diagram.
B
Push contact B over
inner conductor of cable
and crimp.
Splay out and insert
contact B into body C
until stop. Push firmly
against dielectric and
rotate slowly until the
contact B is engaged in
its seat
(max. ½ rotations).
Female connector:
Screw sleeve D on
threaded end of contact B
and tighten with assembly
tool.
Male connector:
Screw pin D threaded end
of contact B and tighten
with screwdriver
Slide ferrule A over
braid and crimp.
0000179881
Old instruction No. 9017
Inner conductor contact:
Outer conductor contact:
C
Feature / Check
Do not damage braid,
dielectric and inner
conductor of cable.
Contact B flush to
dielectric.
Ensure that braid lies
above crimp neck.
Caution:
While you tight the
sleeve/pin D, hold
body C and not the
cable.
Torque : 0.45 Nm
.
Crimp as close to
connector body C as
possible.
crimped
crimped
D
Tools required
Stanley blade
Scissors
Crimp tool:
Cavity 3
For large crimp tool and
table press use insert
76_Z-0-7-1
Female connector:
Assembly tool
74_Z-0-0-89
Male connector:
Screwdriver
Crimp tool:
Cavity D
For large crimp tool
and table press use
Insert 76_Z-0-7-1
Revision D
Date 24.08.2012
Initiator 4779/JPE
Deutscher Text: siehe Rückseite