Table of Contents
Advertisement
Hazard warning
Danger from incorrect operation
The sensor or measuring system may only be operated by trained personnel. The
operating personnel must have read and understood the Operating Instructions.
Electrical hazard
Never immerse the handheld device in water or other liquids. The sensor is not
sensitive to moisture contained in the products typically measured with the sen-
sor.
Connect the handheld device to a correctly installed socket whose voltage specifications meet the
specifications in the Technical Data section using the supplied power supply cable only.
Make sure that the socket is easily accessible so that you can
quickly unplug the power adapter if necessary.
Only use the adapter that suits your socket.
Only operate the measuring device with the original accessories included in the scope of supply.
Contact the manufacturer if you require additional accessories or a replacement.
Do not use the measuring device:
– If the measuring device, sensor, power adapter or accessories are damaged,
– The sensor or measuring system does not work as intended,
– The power cable or plug are damaged,
– The sensor or measuring system has been dropped.
Plug out the power adapter:
– If you will not use the sensor or measuring system for a long time,
– Before you clean, put away or move the sensor or measuring system;
– If you are performing work on the sensor or device, e.g. connecting the devices,
– If a malfunction clearly occurs during operation,
– In a thunderstorm.
Caution - material damage
Make sure to keep a sufficient distance from strong sources of heat, such as hot
plates, heaters etc.
Disconnect the sensor or handheld device from other devices before moving or trans-
porting the device. Plug out the plugs on the device.
Do not use any aggressive chemical cleaning agents,
abrasive cleaners, hard sponges or similar to clean the device.
Page 36
MMP20 SONO Mobil HD2 (option E)
Endress+Hauser
Advertisement
Table of Contents
