Table of Contents
Advertisement
Individual measure-
ment values
To start measuring, press the "Measure" key
symbol appears in place of the battery in the top right-hand corner for the duration of the meas-
urement process. No other actions can be performed during this time. The measurement takes around
4-5 seconds. Once the measurement is finished, the battery symbol appears on the display again. The
individual measurements are displayed on the left of the screen. The last measured value appears at
the top of the list, and older values are displayed one position down. The arithmetic average is dis-
played on the right of the screen. The average value is calculated from the existing individual values
(maximum of six).
Note:
Only a maximum of 6 values can be saved in the list. Older values are removed from
the list and are no longer used to calculate the average.
To delete the series of measurements, press the "Down" key
TIP:
Page 14
Number of the
selected calibration
Remaining
battery
Average of the
measurements
briefly. The device starts measuring and a rotating
With only six measurements in the "mean value"
operating mode, you already receive a representative
measurement result from all measuring points over a
large quantity of material.
MMP20 SONO Mobil HD2 (option E)
.
Endress+Hauser
Advertisement
Table of Contents
