Table of Contents
Advertisement
MMP20 SONO Mobil HD2 (option E)
12 Safety instructions
Sections of this document that require particular attention are highlighted and marked accordingly.
CAUTION:
The warning triangle with an exclamation mark warns against bodily injury or mate-
rial damage.
Designated use
Sensors and measuring systems made by IMKO GmbH may only be used for the described purpose in
compliance with the specified technical data. Use for purposes other than the originally intended
purpose is not permitted. The correct functioning and operational safety of a sensor or measuring
system can only be guaranteed if the standard safety procedures, national regulations and special
safety instructions outlined in these Operating Instructions are adhered to fully.
Moisture sensors and measuring systems made by IMKO GmbH are used for the measurement of
moisture as per the measurement purpose and measuring range defined and specified in the
Technical Data.
Only compliance with the instructions in the manual is considered designated use.
The manual describes how to connect, use and maintain IMKO sensors and IMKO measuring sys-
tems.
Read the manual before you connect and operate a sensor or measuring system.
The manual is an integral part of the product and must be kept in an easily accessible location near
the sensor or measuring system.
Safety is compromised
The sensor or measuring system is designed according to EN 61010 safety require-
ments for electrical equipment, has been tested, and left the factory in a condition in
which it is safe to operate. If the sensor or measuring system can no longer be oper-
ated safely, it must be taken out of service and labeled accordingly to ensure it is not put back into
operation. In case of doubt, the sensor or measuring system must be returned to the manufacturer
or the manufacturer's trade partner for repair or maintenance.
Modifications
For safety reasons, it is not permitted to modify or alter the sensor or measuring system without the
prior approval of the manufacturer.
The sensor or handheld device may only be opened, calibration and repair work may only be per-
formed and all maintenance work apart from the maintenance work described in this manual may
only be carried out by one of our authorized specialists. The sensor or measuring system must be
disconnected from the power supply before any installation work or maintenance work is performed.
The handheld device and the power unit may not be opened or repaired!
Endress+Hauser
Page 35
Advertisement
Table of Contents
