Table of Contents
Advertisement
Quick Links
Owners &
Freestanding Woodstove
Installation Manual
www.regency-fire.com
MODELS:
F2404M
S2404M
Tested by:
Installer: Please complete the details on the back cover
and leave this manual with the homeowner.
Homeowner: Please keep these instructions for future reference.
919-033c
FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St., Delta, BC Canada, V4G 1H4
05.18.17
Advertisement
Table of Contents
Related Manuals for Regency Fireplace Products F2404M
Summary of Contents for Regency Fireplace Products F2404M
- Page 1 Owners & Freestanding Woodstove Installation Manual www.regency-fire.com MODELS: F2404M S2404M Tested by: Installer: Please complete the details on the back cover and leave this manual with the homeowner. Homeowner: Please keep these instructions for future reference. 919-033c FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St., Delta, BC Canada, V4G 1H4...
- Page 2 Thank-you for purchasing a REGENCY FIREPLACE PRODUCT. The pride of workmanship that goes into each of our products will give you years of trouble-free enjoyment. Should you have any questions about your product that are not covered in this manual, please contact the REGENCY DEALER in your area. Keep those REGENCY FIRES burning. “This wood heater has a manufacturer set minimum low burn rate that must not be altered.
- Page 3 Modular Parts F2404 Freestanding Wood Fireplace...
-
Page 4: Table Of Contents
Safety Label for F2404m ..........5 Glass Maintenance ............24 Safety Label for S2404M ..........6 Latch Adjustment ............24 F2404M Unit Dimensions ..........7 Door Gasket ..............24 S2404M Unit Dimensions ..........8 Wood Storage ..............24 Residential Installation ...........9 F2404m Stove Main Assembly ........25 Modular Installation Options ..........9... -
Page 5: Safety Label For F2404M
This is a copy of the label that accompanies each NOTE: Regency units are constantly being Regency Freestanding Woodstove (F2404M). improved. Check the label on the unit and if We have printed a copy of the contents here there is a difference, the label on the unit is the for your review. -
Page 6: Safety Label For S2404M
safety decal NOTE: Regency units are constantly being This is a copy of the label that accompanies improved. Check the label on the unit and if each Regency Medium Freestanding Step there is a difference, the label on the unit is the Stove (S2404M). -
Page 7: F2404M Unit Dimensions
F2404M UNIT DIMENSIONS Contemporary Door Classic Door ALL PICTURES / DIAGRAMS SHOWN THROUGHOUT THIS MANUAL ARE FOR ILLUSTRATION PURPOSES ONLY. ACTUAL PRODUCT MAY VARY DUE TO PRODUCT ENHANCEMENTS. F2404 Freestanding Wood Fireplace... -
Page 8: S2404M Unit Dimensions
dimensions S2404M UNIT DIMENSIONS Contemporary Door Classic Door F2404 Freestanding Wood Fireplace... -
Page 9: Residential Installation
MODULAR INSTALLATION OPTIONS The following items are required when assembling your Regency Stove. F2404M unit - the Rear Heat Deflector is supplied with the stove, but if you choose not to use it you must use the Airmate instead. -
Page 10: Room Air Important
Check with your local inspector. Residential Installation “C” Vent (Single Wall) Unit From Unit From Corner From Flue Center-Line Medium F2404M with Airmate 16" (406 mm) 11" (279 mm) 6" (152 mm) 28" (710 mm) 17.5" (444 mm) 17.5" (444 mm) with Rear Deflector 18"... - Page 11 Min. Min.Hearth Unit Unit Center-line Width to Rear Wall Medium F2404M with Airmate 15" (381 mm) 5.5" (139 mm) 27" (685 mm) 12" (304 mm) 54" (1371 mm) 48" (1219 mm) with Rear Deflector 15" (381 mm) 6.5" (165 mm) 27"...
-
Page 12: Stove Assembly Prior To Installation
The rear heat deflector is supplied with the stove 1) For easier assembly, tip the stove on its back tached to the base. The F2404M stove requires and must be installed unless the optional airmate (onto a soft surface to prevent scratching). -
Page 13: Chimney And Connector Installation
Leg and Bottom Shield Assembly CHIMNEY AND flue collar to the chimney support device. F2404M & S2404M CONNECTOR 9) If you are using a horizontal connector, INSTALLATION Bottom Shield 020-911 the chimney connector should be as high as possible while still maintaining the 18"... -
Page 14: Masonry Chimney
installation 14 | MASONRY CHIMNEY Ensure that a masonry chimney meets the mini- mum standards of the National Fire Protection Association (NFPA) by having it inspected by a professional. Make sure there are no cracks, loose mortar or other signs of deterioration and blockage. -
Page 15: Combustible Wall Chimney Connector Pass-Throughs
installation COMBUSTIBLE WALL CHIMNEY CONNECTOR PASS-THROUGHS Method A: 12" (304.8 mm) Clearance to Combustible Wall Minimum chimney clearance to brick and combustibles 2 in. (50.8mm) Member: Using a minimum thickness 3.5" (89 mm) brick and a 5/8" (15.9 mm) Minimum clearance minimum wall thickness clay liner, construct a wall pass-through. -
Page 16: Recommended Heights For Woodstove Flue
installation 16 | RECOMMENDED HEIGHTS FOR WOODSTOVE FLUE 3) Add 4% overall for each 1000' above sea Recommended Flue Height Simple rules on draft (refer to Table 1). level. Elevation Example a) Example b) 1) At sea level minimum height is 12' straight. Example: a) 1000' 18.72'... -
Page 17: Mobile Home Installation
installation MOBILE HOME INSTALLATION In addition to standard installation instructions the following requirements are mandatory for installation in a mobile home. Once you have properly marked the position of your unit and the floor protection as outlined in 1) The stove must be permanently bolted to the Residential Installation items #1 through #8, the floor of the Mobile Home using the floor a supply of fresh air has to be supplied to your... -
Page 18: Listed Components For Mobile Home Installation
ICC EXCEL 2100 tap it into place with a hammer. A tighter fit The Regency F2404M and S2404M Freestand- Qty.Part # Description will ensure the tube will not move when the... -
Page 19: Stainless Steel Smoke Deflector Adjustment / Replacement
installation STAINLESS STEEL SMOKE DEFLECTOR ADJUSTMENT / REPLACEMENT The stainless smoke deflector is located in the upper front area of the firebox. The deflector is held in place with 2 bolts Prior to the first fire, ensure deflector is seated properly and secured with 2 hand tightened bolts. Smoke deflector installed with 2 bolts. -
Page 20: Brick Installation
installation 20 | BRICK INSTALLATION 4) Push the ash plug into the hole inside the STEP-BY-STEP firebox and replace all the bricks except OPTIONAL for the brick over the ash plug (see brick Firebrick is included to extend the life of your diagram in the Brick Installation section). - Page 21 installation Blower/Fan (846-515) 1) Remove the two screws from the top of the #8 Groun Lug fan housing. Grounding Ground wire Lug Detail from fan 2) Slide the fan up into the rear heat shield. Lockwasher Star washer 3) After aligning holes, secure the fan to the rear heat shield using the two screws removed Star washer Ground wire...
-
Page 22: Operating Instructions
operating instructions 22 | OPERATING FIRST FIRE ficult to start the fire. As you dry out your firebrick and your masonry flue, your draft INSTRUCTIONS will increase. When your installation is completed and inspected you are ready for your first fire. With your unit now correctly installed and safety 10) For those units installed at higher elevations inspected by your local authority, you are now... -
Page 23: Fan Operation
operating instructions 4) If you have smoke detectors, prevent smoke FAN OPERATION Push the ashes down the hole into the ash spillage as this may set off a false alarm. drawer, the large pieces can be left in the firebox and burned during the next fire or Automatic 5) Do not overfire heater. -
Page 24: Maintenance
maintenance 24 | MAINTENANCE 5) The chimney and chimney connector should LATCH ADJUSTMENT It is very important to carefully maintain your be inspected at least once every two months fireplace stove, including burning seasoned during the heating season to determine is a wood and maintaining a clean stove and chim- The door latch may require adjustment as the creosote buildup has occured. -
Page 25: F2404M Stove Main Assembly
820-184 Glass Retainer Clips (8/set) 910-157/P Fan/Blower Motor (120 V) Screw - 1/4 - 20 x 3/8" 033-953 Air Tube - 3/4" F2404M (Qty: 4) (each) 948-170/P Small Glass Retainer F2404M 020-957 Baffle (set) F2404M 020-363 Left Side Heat Shield... -
Page 26: S2404M Step Stove Main Assembly
parts list 26 | S2404M STEP STOVE MAIN ASSEMBLY Part# Description 948-102 Spring Handle - Small Gold 948-136 Spring Handle - Small Nickel 850-142 Door Assy - Gold Part# Description 850-141 Door Assy - Black 850-143 Door Assy - Nickel Accent 846-515 Complete Fan/Blower Assy (120 V) 850-144... -
Page 27: Pedestal, Bottom Shield & Leg Options
parts list PEDESTAL, BOTTOM SHIELD & LEG OPTIONS Part# Description 020-915 Pedestal - Medium 904-257 Large Magnet Catch Blanking Plate - Pedestal 850-100 Ashdrawer Kit - Pedestal Ashdrawer - Pedestal Ashdrawer Lid Assy 942-110 Ash Plug 820-249 Ash Plug Tool Handle 020-911 Bottom Shield - Medium Blanking Plate - Btm Shield... -
Page 28: Firebrick
parts list 28 | FIREBRICK Part# Description 020-960 Brick Set - Complete 902-111 Brick - Regular Full Size: 1-1/4" x 4-1/2" x 9" Brick Partial: 1-1/4" x 4-1/2" x 3-1/2" Brick Partial: 1-1/4" x 4-1/2" x 2" Brick Partial: 1-1/4" x 2" x 9" F2404 Freestanding Wood Fireplace... - Page 29 notes F2404 Freestanding Wood Fireplace...
- Page 30 warranty 30 | Limited Lifetime Warranty FPI Fireplace Products International Ltd. (for Canadian customers) and Fireplace Products U.S., Inc. (for U.S. customers) (collectively referred to herein as “FPI”) extends this Limited Lifetime Warranty to the original purchaser of this appliance provided the product remains in the original place of installation. The items covered by this limited warranty and the period of such coverage is set forth in the table below.
-
Page 31: Warranty
warranty All warranty claims must be submitted by the dealer servicing the claim, including a copy of the Bill of Sale (proof of purchase by you). All claims must be complete and provide full details as requested by FPI to receive consideration for evaluation. - Page 32 warranty 32 | Limitations of Liability: The original purchaser’s exclusive remedy under this warranty, and FPI’s sole obligation under this warranty, express or implied, in contract or in tort, shall be limited to replacement, repair, or refund, as outlined above. IN NO EVENT WILL FPI BE LIABLE UNDER THIS WARRANTY FOR ANY INCIDENTAL OR CONSEQUENTIAL COMMERCIAL DAMAGES OR DAMAGES TO PROPERTY.
- Page 33 warranty Product Registration and Customer Support: Thank you for choosing a Regency Fireplace. Regency strives to be a world leader in the design, manufacture, and marketing of hearth products. To provide the best support for your product, we request that you complete a product registration form found on our Web Site under Customer Care within ninety (90) days of purchase.
- Page 36 Installer: Please complete the following information Dealer Name & Address: ______________________________________________ ___________________________________________________________________ Installer: ___________________________________________________________ Phone #: ___________________________________________________________ Date Installed: ______________________________________________________ Serial No.: __________________________________________________________ Regency and Classic are trademarks of FPI Fireplace Products International Ltd. Printed in Canada © Copyright 2017, FPI Fireplace Products International Ltd. All rights reserved.
Need help?
Do you have a question about the F2404M and is the answer not in the manual?
Questions and answers